Radial Thrust Ball Bearing Centrifugal Water Pump with Cast Iron Material

Supported By Radial-Thrust Ball Bearing Centrifugal Water Pump Made By Cast Iron

Description:

There are some pipe screw holes on the inlet and outlet flanges which are used to install vacuum gauge and pressure gage; there are some holes on the bottom of the inlet and outlet flanges which are used to draw off the water. The impeller is tested with dynamic balance. It is fixed by shaft sleeve and shaft sleeve nut, and the axial position can be adjusted by the shaft sleeve nut. The axial force of the impeller can be balance according to the symmetrical arrangement of the impeller. And the bearing on the shaft end will bear the surplus axial force. Pump shaft is supported by two sing-row radial ball bearings or four radial-thrust ball bearings.

Feature:

1. Superior high and medium head performance.

2. More efficient and dependable than virtually any other pumps.

3. Improved 1-1/2, 2, 3 and 3-1/2 HP flow.

4. Ultra rapid priming.

5. Ultra quiet.

6. Anti spin-off impeller.

7. Giant strainer basket.

8. Stainless steel port reinforcement.

9 Heavy duty with ultra performance to both high and medium head installations in large-size swimming pools/commercial spa pools.

Application:

1. Irrigation and drainage, spray irrigation

2. Groundwater drainage and management

3. Industrial and municipal water supply

4. Pressure boosting

5. Raw and service water supply

6. Handling clean or slightly contaminated water

7. Drinking water supply

Hot Water Centrifugal Pump

irrigation water pumps

Radial Thrust Ball Bearing Centrifugal Water Pump with Cast Iron Material Images